Warhammer Dark Omen Forum

Warhammer Dark Omen => Help Section => Topic started by: gesaugen on September 14, 2010, 09:55:33 PM



Title: Can't cange rendering device to 3D
Post by: gesaugen on September 14, 2010, 09:55:33 PM
I've managed to start and play DO on my Win 7 64bit by following install tutorials. But problem is that "rendering decice" is set to software and 3D is grayed out... because I have CRT wich goes 100hz @ 1280x1024 i think that I wouldn't have problems with flickering...
so I've tryed to set rendering device to 3D via registry but haven't succeeded... only thing that I succeeded via registry was to enable landscape and light rendering wich were grayed too and game runs fine with those

so, what should I cange to sed rendering device to 3D? Also it would be nice to know how to enable sprites rendering

help?


Title: Re: Can't cange rendering device to 3D
Post by: Ghabry on September 14, 2010, 10:28:39 PM
3D Mode is disabled because you installed the VistaFix.
Uninstall it via the control panel. (Control Panel -> Installed Programs -> DOFix (or VistaFix, no idea))
If you cant find it there just rename EngRel.exe to something else but this will cause problems with game ranger.
I think the detection was based on if there is tshooter.exe in ../
So other way to disable it is renaming tshooter.exe ;).

What registry settings have you changed to enable these features in CPU mode? And are you sure that they are really enabled (= you can see a difference in game).